Simes s 4655w 14 step led 930 gr

TYPE Wall mounted luminaire Protection rating IP 65 MATERIAL CHARACTERISTICS Body in extruded EN AW-6060 and die-cast EN AB-47100 primary aluminium with high resistance to oxidation Tumbling process for preparation for the painting phase Screws in A4 stainless steel with a high molybdenum content of 2.5-3% Annealed silicone gaskets Extra-resistant double painting carried out in 3 phases: 1) BONDERITE treatment with chemical protection of metal-free fluozirconic material containing ceramic nanoparticles that create a cohesive, inorganic, high density layer 2) PRE-POLYMERIZATION cycle with application of epoxy primer with characteristics of over-paintableness of the luminaire and high resistance to oxidation thanks to the presence of zinc 3) POLYMERIZATION cycle with the application of polyester powder with high resistance to UV rays and atmospheric agents, with resistance to salt spray test of 1200h Mechanical resistance IK 06 LIGHTING PERFORMANCE Optical reflector in white plastic material Transparent tempered safety glass, 4 mm thick Light source, with fixed lamp position Efficiency -- The upper part of the device has a grid that acts as a radiator, to dissipate the heat developed by the LED positioned just below INSTALLATION AND MAINTENANCE The housing has a depth reduced to a minimum: with its 70mm it can in fact also be walled in partition walls Made of polypropylene, it can be installed flush with the floor, or at a height of about 20cm from the ground, depending on the desired effect The lamp unit is completely extractable via a spring mechanism; this simplifies maintenance operations, but makes it more suitable for use in environments where there is no risk of vandalism