Simes s 6675w 14 loft q sof 5led 930 fl grey

TYPE
Downlight. IP 65 protection rating.

CHARACTERISTICS OF THE MATERIALS
Die-cast aluminum structure EN AB-47100 with low copper content and high resistance to oxidation. Tumbled finish for preparation for the painting phase. Screws in A4 stainless steel with a high molybdenum content of 2.5-3%. Gaskets in annealed silicone.
Extra-resistant double painting carried out in 3 phases:
1) BONDERITE treatment with a metal-free fluozirconic chemical protection material containing ceramic nanoparticles that create a cohesive, inorganic, high-density layer. 2) PRE-POLYMERIZATION cycle with application of an epoxy primer with characteristics that allow the device to be overpainted and with high resistance to oxidation thanks to the presence of zinc. 3) POLYMERIZATION cycle with the application of polyester powder with high resistance to UV rays and atmospheric agents, with resistance to the salt spray test for 1200 hours. Mechanical resistance IK 06

LIGHTING PERFORMANCE
Miniloft Ceiling S.6646W and S.6646N available from December 2019 with new comfort optics. Loft Ceiling S.6675W and S.6675N available from November 2019 with new comfort optics.
Optical reflector in 99.98% pure anodized aluminum, turned, anodized and polished (versions with TC and HIT bulb). Transparent tempered safety glass. Light source, with lamp position tilting ±15°. Efficiency --

INSTALLATION AND MAINTENANCE
MICROLOFT cable @@{TipoCavo}@@ resin-coated and pre-wired. MINILOFT and LOFT with pre-wired base and disconnect switch make installation and maintenance operations easier and safer.

WIRING
Single entry for power cables .
Insulation class: CLASS I
Available colors: White (code 01), Aluminum gray (code 14), Anthracite gray (code 24) Weight: 3.8067 Kg Glow Wire test: --
Fixtures supplied complete with LED module

LOFT REGISTERED MODEL

This device features integrated LED modules. In case of damage or malfunction, contact the manufacturer for additional instructions on how to replace the LED module and related components. The LED module in this device cannot be handled by the end user (EU Regulation 874/2012).

This product contains a light source of energy efficiency class (EPREL - European Product Registry for Energy Labelling): E.

LED module designed in accordance with the current Lumen Maintenance Regulation (LM80) and Technical Memorandum (TM21), where the light quality is reliable for a lifetime of 70,000 hours referred to L80 B10 Ta 25°C (50,000 hours referred to L80 B10 Ta 40°C). Luminaire lifespan min. 70,000 hours Ta 25°C, min. 50,000 hours Ta 40°C. Performance ambient temperature Tq 25°C. Operating ambient temperature -20°C to +50°C. Storage temperature -20°C to +60°C.

ELECTRONIC EQUIPMENT SENSITIVE TO OVERVOLTAGE.
It is recommended to install surge protection devices (SPD) in the electrical system.Protective devices prevent the intensity of these phenomena, protecting fixtures from damage and prolonging their life. Outdoor lighting fixtures are subject to all types of permanent, temporary, or transient electrical disturbances. These disturbances can cause permanent damage or failures that compromise their performance and lifespan. Surge protection devices (supplied by SIMES) are used to limit the destructive effect of these phenomena. A protective device must be installed for each lighting fixture no more than 10 meters away. To ensure proper coordination of the protection devices, a surge protection device must also be included within the system's electrical power panel (the choice of this device is the responsibility of the designer and is not supplied by SIMES).