Disano 16453300 hydro //el 921 fl2x18 elf gri

BODY: Injection moulded in RAL7035 grey polycarbonate, shatterproof and self-extinguishing V2, with high mechanical resistance thanks to the structure reinforced by internal ribs DIFFUSER: Injection moulded in transparent polycarbonate with internal prismatic structure for greater light control, self-extinguishing V2, UV-stabilised. The smooth external finish facilitates cleaning, which is necessary to always have maximum light efficiency REFLECTOR: In cold-rolled steel, hot-dip galvanised to prevent cracking, coated with 7//8 micron epoxy primer, UV-stabilised anti-yellowing paint in glossy white polyester, thickness 20 microns LAMP HOLDER: In white polycarbonate and phosphor bronze contacts G13 connection WIRING: Power supply 230V//50Hz, with electronic ballast Rigid cable section 0 50 mm² covered with PVC-HT resistant to 90°C, according to CEI standards 20-20 2P T terminal block with fuse holder, maximum permitted conductor section 2 5 mm² EQUIPMENT: Protection fuse 3 15A Cable gland in fibreglass nylon diam 1//2 inch gas Gasket in ecological expanded polyurethane material Locking hooks in fibreglass nylon Predisposition for tightening with steel screws REGULATIONS: Produced in compliance with the current EN 60598-1 CEI 34-21 standards, protection degree IP66IK08 according to EN 60529 Can be installed on normally flammable surfaces Has obtained the European ENEC conformity certification Resistant to the glow wire test for 850°C THE WATERPROOF FRAMEWORKS in polycarbonate of the Hydro series have a watertightness degree IP66IK08 if installed in environments with temperatures not exceeding 45°C Direct exposure to sunlight easily leads to temperatures exceeding 45°C compromising the degree of protection However, it is recommended to use a waterproof housing. to use them appropriately without altering their mechanical and protection qualities (IP66IK08) and not to install them on surfaces subject to strong vibrations, exposed to atmospheric agents, outside on ropes or poles, on walls, under metal grates or in any case directly exposed to sunlight, otherwise use watertight steel armouring